Terminating the WK-MOD
It is important to terminate WK-MOD correctly otherwise the wired
system will not function. The termination that is required depends
on the nature of the installation and the position of the RAK-LINK
within the system.
No Term - Both Jumpers removed
Used when the WK-MOD is not at the end of line. This is usually
identifiable by two cables being punched down to the WK-MOD.
Term - Jumper fitted across 1+2 & 4+5
Used when the WK-MOD is “end of line” in a daisy chain
configuration. For example the WK-MOD marked “TERM” shown
in “Typical Wired Installation layout” on page one.
Star Term - Jumper fitted across 2+3 & 5+6
Used when the WK-MOD is “end of line” in a STAR wire
configuration. For example the WK-MOD marked “STAR TERM”
on page one.
Programming the WK-MOD
The WK-MOD is programmed using the Rasoft Pro programming software. A WK-HUB or
WA/WTC-Bridge is required for any programming of a wired system.
To put the WK-MOD into setup mode:
-
Press and hold any button on the WK-MOD
-
Whilst keeping this button held down press any other button three times
-
The backlit LEDs will begin to cycle to indicate the keypad has entered setup mode
Wired system Programming Guide
- For information on how to program the wired system
using Rasoft Pro.
WK-MOD
Manual Version 1.0.2
