Before installing the WK-MOD:
The WK-MOD comes in two sections “Front” and “Back” ; they are referred to as such in
the following installation guide.
NB
The “Back” section is just a connection board for the CAT5/6 cable. The “Front” section contains all
memory and programming
-----------------WARNING---------------
The WK-MOD has four visible screws on the “Front” section as shown below:
These must not be adjusted. Adjusting these may damage WK-MOD-xxx-x
Installation of the WK-MOD-xxx-x with HS-MOD-xx :
Before installing the WK-MOD separate the “front” and “back” sections
Step 1
Prepare cable(s) in backbox (minimum 35mm)
ready for connection.
Separate the two halves of the WK-MOD ready
for installation.
Where metal back-boxes are used it is important
that the adjustable lug (if present) is on the left or
right hand side.
Step 2
The “back” section (with the punchdown
connections) will be installed first.
Punch down cable(s) matching cable colours to
connection colours as shown on the circuit board.
There may be either one or two sets of cables to
punch down.
WK-MOD
Manual Version 1.0.2
