RAIS attika Q-BE INSERT, User Manual

Page: 67 / 224

11
A-A
C-C
A A
C
C
A=50mm / B=350
A=100mm / B=0
A
A
B
10
0,5
°
Møblerings afstand
B
English RAIS/
attika
- User Manual Q-BE INSERT
Q-BE INSERT - Installation of the insert
Installation materials:
• 12,5 mm Fermacell panels
• calcium silicate panels (eg. 50 mm Super Isol or Skamotec 225)
• bricks
Hole measurements (height x width x depth) min. 918 x 399 x 399 mm (int. size).
When the stove is placed against a combustible wall, the back and side walls should be installed
with Fermacell 12.5mm or 50mm calcium silicate panels.
The stove with the panels should have convection holes above and below.
A fireplace insert shall never be installed too tightly, since steel works in heat.
Convection area must
be at least 200 cm
2
both above and below
the stove (can be dis-
tributed).
When you choose where to set up your RAIS/
attika
wood burning stove, you should con-
sider the heat distribution to the other rooms. This will enable you to get the best use out of
your stove.
See the manufacturer’s plate on the wood burning stove.
Upon receiving the stove must be inspected for defects.