RAIS 800, User Manual, Page: 11 / 32

ENGLISH RAIS - manual for RAIS 800
11
Installation of stove:
NOTE:
Decision to be taken concerning the placement of the inlets and outlets of the
convection system. The area requirements for convection holes to be kept.
Miscolouring of the wall above the doors and the convection air outlets may
occur due to raising hot air.
RAIS cannot take responsibility for building in or consequential damage.
The stove to be inspected for defects at receipt.
Lift the stove from the pallet to the place of installation on a suitable floor protection. If
the stove is to be placed higher a pedestal can be used (buy accessories at your local RAIS
dealer)
The stove is aligned by adjusting screws, so the lower edge of the glass door is in horizon-
tal position and the surface of the door is vertical when the door is closed.
Remove the door from the stove. Be careful not to damage the glass on the door. Keep
the protective tape and plastic on the handles. Protect the painted stove body against
spray of cement and paint.
Install the flue pipe on the flue outlet inside the convection box.
It is important that there are no leakage between the flue pipe and the stove. It is re-
commended to seal the connection by suitable gasket or compound.
Conect the flue pipe and connect to chimney.
Install fresh air inlet connection to the pipe stub if such is to be installed.
The stove is now ready for building into either panels or brick wall.
After establishing the wall and eventually painted, the door is mounted again and if
wanted the front panels can be mounted using suitable cement compound. Remove all
protective plastic and tape.
It is possible to deliver front panels in special measures if needed together with the stove.
Contact your local RAIS dealer.
Installation instructions