QUICK INSTALLATION INSTRUCTIONS
The Polaris ATV cycles on/off with the pool filtration pump, vacuuming and cleaning all
surfaces randomly throughout the pool. The climbing ability of the Polaris is dependent on
the pool’s shape and available water flow. It will climb better in pools without sharp angles or
curves in the transition from the pool floor to the pool wall.
Approximately every 4-1/2 minutes the Polaris ATV completes one cleaning cycle. During a
cycle, the Polaris travels both forward and backwards, and pivots to the right and left. The
bypass door releases the cleaner from obstacles and the fan creates down force to increase
cleaner stability.
Bottom Plate
The bottom plate helps the Polaris travel over sharp corners or high spots. Periodically check
the bottom plate for wear and replace as necessary.
Propeller
Keep propeller free of debris. To access the propeller area, remove the top housing assembly.
Flow Regulator
Periodically check the inlet in the flow regulator and clear away debris.
Emptying the Pump Basket
For the Polaris to operate at optimum efficiency, empty the pump basket regularly. The more
debris in the pool, the more often the pump basket should be cleared.
Backwashing the Pool Filter
Always disconnect the Polaris from the pool wall before cleaning or backwashing the pool
filter. After cleaning or backwashing, let the filtration system run for at least five minutes to
flush out the suction lines before re-connecting the Polaris.
Storage and Winterizing
Never store the Polaris in direct sunlight. When storing for the winter, drain out all the water
(freeze damage is not covered by the warranty). Remove all connectors and adapters from
the dedicated suction line or skimmer.
