Rain Bird WS-PRO2, Installation, Operation, Maintenance And Troubleshooting

Page: 37 / 64

WS-PRO2 Weather Station Manual
GT
27176
Page 37 of 61
Figure 25
Replace the connector cover. The tab at the top of the connector cover
slides into the opening on the back of the cross arm. Ensure that all cables
and connector caps are under the cover before tightening the Phillips
screw at the bottom of the cover. Make sure that all cables coming out of
the top right of the connector cover are not being pinched. See Figure 25.
Tighten down the wire ties holding cabling to the wire tie harness and clip
off any excess.
4.2 Communication and Data Storage Peripherals
Only one communication kit can be mounted inside the ET enclosure.
Communication kits ordered with the ET Enclosure are pre-mounted and pre-
wired; no further connections inside the enclosure are necessary. Follow the
"External Installation" procedures in later sections to make the external
connections.