4
Sets run time per station from 1 to 99 minutes
£
Press once to set station 1
£
Press again to set station 2
£
Repeat for other stations
£
To remove a station from watering on a
program, set time to "00"
STATION
TIMING
Allows watering cycle or station to be manually started
£
Press once to set station 1
£
Press again to advance
MANUAL
START &
ADVANCE
SYSTEM
OFF
/
AUTO
Cancels any in-process operation and turns system off during rain
(Last digit flashes)
Location
Select an indoor location within six feet of
a grounded electrical outlet.
CAUTION!
This is not an outdoor timer.
Do not mount it where it is exposed to wa-
ter, moisture or direct sunlight, as
failure may occur.
Tip!
To avoid power fluctuations, do not
put the timer on a circuit controlled by a
switch, or on a circuit supplying high
power equipment.
Cover Removal
Remove the front cover by depressing the
bottom tab and lifting as shown in
figure 1.
Mounting
Mount the timer to a wall using two #10 screws installed at centers 3
13
/
16
" apart at eye
level. Use plastic anchors to secure screws if the wall is plastic or masonry. Leave the
screw heads extended ¼" and hang the Rain Clock using the keyhole slots on the
back. Install a third screw through the mounting hole (located below the battery area)
Press Here
Lift
FIGURE 1
Mounting Instructions
