Install The +LINK Radio/Modem Kit
+LINK Power Transformer
Installation & Connection
NOTE:
!
Follow this procedure only for wireless
systems without a Radio/Modem Kit (RMK)
pre-installed�
CAUTION:
F
To avoid a serious shock hazard,
make sure the primary AC power source to
the controller is OFF�
Install the +LINK Power Transformer (P/N 633254) in the
transformer wiring compartment in the space to the left of
the main PAR+ES Power Transformer. (See Figure 9).
Remove the two screws securing the Power Supply
1.
Access Cover.
Remove the two screws from the reverse side of the
2.
power supply and the one screw from the bottom of
the power supply.
Remove the secondary power connector from the
3.
power interface board.
Remove the main AC power connector from the
4.
snap-in terminal block.
Insert the +LINK transformer into the power supply
5.
and run the orange wires through the hole in the top
of the compartment.
Feed the wires through the power supply hole and
6.
secure the transformer using the nuts provided.
Attach the green ground wire to the grounding post.
7.
Plug the +LINK transformer’s white male connector
8.
into the free white female power supply connector.
Replace the power supply in the controller and secure
9.
it with its screws.
Reattach all power connections.
10.
+LINK Interface Board Installation
The +LINK Interface Board mounts under the control
module (face panel) of the basic PAR+ES controller
Remove the four screws from the face panel bezel (not
1.
the interior face panel screws) and lift out the control
module.
Use four #4-40 machine screws to attach the +LINK
2.
Interface Board module to the bottom of the control
module (see Figure 10).
Attach the 10-pin ribbon cable from the connector on
3.
the left end of the +LINK Board to the 10-pin connector
on the left end of the Power Interconnect Board.
Attach the nine-pin Radio/Modem data cable into the
4.
connector on the bottom of the +LINK Board. Pass the
cable through the opening between the bezel tray
and the plastic pedestal itself.
Plug the other end of the nine-pin cable into the
5.
Radio/Modem link module.
Plug the link transformer power Wire Connector in the
6.
two-pin connector.
Replace the Control Panel Assembly and continue
7.
with the installation.
PAR+ES Installation Manual
8
635778 Rev B (PAR+ES installation manual (1of2 ENG)) source.indd 8
9/2/2008 4:09:43 PM
