13
Mount Controller
Œ
Place the supplied mounting template in the desired location on the wall. Mark the screw center locations by
punching through the template with a sharp tool.
•
Remove the template. Two plastic spacers are provided for the upper mounting screws only. (See illustra-
tion on the next page.)
Slip the spacers over the screws and drive them into the wall or stud at the upper keyhole marks: holes A
and C for flat surfaces, or hole B only for an exposed stud.
When the wide, flat end of the spacer is pressed against the wall or stud, the screw is at the proper depth.
Do
not
drive a fastener into location D at this time.
Ž
Remove the controller’s lower face panel by gently prying out the panel at the slots on the left and right
sides.
•
Hang the controller on the upper keyhole slots. Make sure the spacers are in the upper, narrow portion of
the slots. Then drive a fastener through lower mounting hole D, located just to the right of the fuse. The
controller should now be secure.
Technical Support:1-800-RAIN BIRD
This Manual: http://www.manuallib.com/file/2721363