Rain Bird ESP-12LX+, Installation, Programming, And Operation Manual, Page: 51 / 73

48 ESP-LX+ & LXi+ Installation, Programming, & Operation Guide
Remove Door and Face Panel
Before you mount the controller, we recommend that you
remove the door and face panel. Although these steps are not
absolutely necessary, they will make installation more conve-
nient.
➊
Open the door and swing it to the left. If necessary, unlock
the door with the supplied key.
➋
Flip the upper tip of the hinge pin out of the groove in the
door so it is pointing at you.
➌
Support the door and slide the hinge pin upward until it
clears the hinges. Then remove the door.
➍
Open the face panel by grasping its lower right corner and
swinging it to the left.
➎
Disconnect the ribbon cable by grasping it along its two
flat sides. Then pull the cable gently out of its connector.
➏
Unplug the two-wire harness by releasing the latch on the
side of the connector. Then pull the connector away from
the terminal board.
➐
Press down on the upper flexible hinge to release the
hinge knob from its hole in the cabinet.
➑
Pull the lower hinge knob out of its hole and remove the
panel.
To reconnect the face panel and door, repeat the steps above
in reverse order. Make sure to reconnect the ribbon cable and
two-wire harness to their connectors for proper controller
operation.