Raider RDP-ETC27, User Manual

Page: 15 / 78

15
top of the table or the fence on the back edge
of the table.
● Pull the sliding table back far enough
from the blade to place the tile on the table.
● Turn on the on/off witch. Allow the blade
to come up to full speed. Check that the blade
looks wet.
● Using both hands, hold the tile securely
against the fence at the back edge of the
sliding table.
WARNING! Do not allow your hands or
fingers to protrude over the notches at the
back edge of the sliding table. The blade will
enter this space during the cutting operation.
● Slowly push the sliding table and tile
forward into the blade. Feed the tile smoothly
into the blade. Do not apply heavy pressure to
bump the tile against the blade.
● Carefully follow your working line
adjusting tile cutting position if required.
● Never cut dry. Be sure the blade remains
wet during cutting operation. Frequently
check the water level in the water tray and
add water as often as necessary. Make sure
the pump is well below the water level.
● If the motor slows down, slow down your
feed rate or pull the tile smoothly back from
the blade.
● Wipe clean top with sponge during use
to reduce build up of debris. Always ensure
the machine is switched off when carrying out
this action.
● Stop the machine by using the on/off
switch. Allow the blade to come to a stop on
its own. Do not manually stop the blade by
grabbing it or holding an object against it.
WARNING! Do not attempt to pick up an
off-cut or to remove the holding tile before the
cutting blade has completely stopped.
● Remove the plug from power supply after
use. Empty the water tray, clean the machine
and pump. Lock the sliding table before
maintenance, transportation or storage.
7. Straight Cutting
● Loosen the screw knob of the mitre
gauge.
● Fit the mitre gauge onto the left side
fence at the back edge of the sliding table.
● Set the mitre gauge to the desired size
using the embossed ruler guide.
● Relock the screw knob.
● Position the tile against the fence of
the sliding table and against the mitre gauge
when cutting.
8. Diagonal Cutting
● Loosen the screw knob of the mitre
gauge.
● Fit the mitre gauge onto the left side
fence at the back edge of the sliding table.
● Set the mitre gauge to the distance
required.
● Relock the screw knob.
● Loosen the angle adjustment knob at the
top.
● Adjust to the desired angle (from 0º to
45º).
● Relock the angle adjustment knob.
● Place the tile against the mitre gauge
when cutting.
9. 45 Degree Bevel Cutting
● Pull the sliding table back far enough to
clear from the blade.
● Loosen the angle adjusting knob on the
back of the motor assembly.
● Pivot the motor assembly to 45 degree
position..
● Relock the angle adjusting knob.
● Loosen the height adjusting knob on the
front of the motor assembly.
● Lift the motor assembly to its highest
point position.
● Relock the height adjusting knob.
● Push the sliding table forward slowly to
check that the blade should not contact either
the 45 degree cutting groove on the top of
the table or the fence on the back edge of the
table.