Raider RDI-HD45, User Manual

Page: 13 / 98

13
5.1.Operating modes:
• Impact drilling
Push the release button and insert the “Punctuation” symbol switch. The switch comes in the right position with a crisp click.
After long running at low speed, you must cool the power tool.
Periodic breaks should be made in the work.
Be careful not to cover the openings in the engine housing to ventilate the engine.
It is not necessary to change the operating mode when the shunt spindle is rotating!
When a large diameter hole is to be drilled, it is recommended to drill a smaller hole first,
then be punched to the desired size. This will prevent overloading the breaker. Drilling of deep
holes should be carried out gradually by removing the bore from the hole periodically to remove chips or dust.
If the drill bit clicks into the opening during drilling, you must immediately release the breaker breaker breaker.
Use the change of rotation direction to remove the drill from the hole. The bumper must be held in alignment with the
drill hole. Ideally, the drill should be placed perpendicular to the surface of the workpiece. If the condition
of perpendicularity is not observed, it may result in jamming or breaking of the drill in the hole as well as injury to the user.
• Chiselling mode
Press the release button and turn the mode switch
Make periodic breaks in work.
Store and handle the accessories carefully.
Do not throw the tool, do not overload it, immerse it in water or other liquids, do not use it to mix glue and concrete screed.
6. Service and maintenance.
6.1. Do not use water and any chemical liquids to clean the shaker. It should only be wiped with a piece of dry cloth. It should
always be stored in a dry place and the ventilation holes in the housing are free and clean.
6.2. Replace carbon brushes.
Worn (shorter than 5 mm), burned or broken carbon brushes on the motor should be replaced. Always replace both brushes
at the same time. Only work with carbon brushes to qualified technicians who have original spare parts in the RAIDER
workshop.
6.3. Repairs to your power tools should only be performed by qualified RAIDER workshop specialists, where only original
spare parts are used. This ensures safe operation of power tools.
7. Environmental protection.
In order to protect the environment, the power tool, accessories and packaging must be suitably processed for the reuse of
the raw materials contained therein.
Do not dispose of power tools in household waste! According to the European Union Directive 2012/19 / EU on end-of-life
electrical and electronic devices and the validation and as a national law, power tools that can no longer be used must
be separately collected and subjected to appropriate processing for recovery of the contents making them valuable raw
materials.