Raider RD-TS10, User Manual, Page: 12 / 56

22
23
www.raider.bg
Do not loosen screw nut A, and assemble the
part 18. Adjust the position from it to the blade
according to the measure in the figure, then
tighten the screw nut A (fug. 17)
Bring down the blade, insert the part 19, then use
6 pcs M6 x 16 cross-counter-sunk screw to fix it
(fig. 18)
Use M6 x 25 cross round head screw, M6 locked
screw nut to assemble the part 20 on the part 18
(fig. 19).
Use the part 21 to connect the blowing-wind hole
in the part 20 and in the part 14, then clip the part
21 on the part 7 (fig. 20).
Use 2 pcs M6 x 16, 2 pcs M6 papilionaceous
screw nut to assemble the part 23 on the part 24
(fig. 21)
Push the assembled part into the chamfer of the
guide, use 2 pcs M6 x 30 semi-round head square-
neck screw. 2 pcs M6 screw nut to assemble it in
the position of A and B. Tighten the screws firmly
and make the part 24 stable. Then loosen the
screw nut to make the part 24 move freely in the
chamber of the guide (fig. 22)
Use 2 pcs M6 x 30 semi-round head square-neck
screw, 2 pcs M6 big flat washer to assemble the
part 22 (fig. 23). Use the same way to make the
part 24 move freely
in the chamber of guide.
Use 2 pcs M6 screw nut to fix the part 25 on the
part 3 (fig. 24).