12
www.raider.bg
sanding/grinding disk. Before you start the equipment, check to ensure that the attachments
are securely installed.
Never touch the area you wish to polish with the edge of the sanding/grinding disk.
Use the speed selector to select the following maximum speeds for polishing:
- Working in polish: approx. 1000 rpm
- Polishing to a high gloss: approx. 1000-1100 rpm
- Polishing up: approx. 1400 rpm
If you do not comply with these instructions, the manufacturer cannot accept any liability.
The Velcro fastener enables easy changing of the polishing attachment.
- Use the foamed plastic attachment to apply the polishing agent.
Make sure that the foamed plastic attachment is free of any foreign bodies.
Spread the polishing paste evenly over the polishing pad. Do not apply the polish directly
to the polishing surface.
Switch the polishing machine on and off only when the polishing machine is resting on the
polishing surface.
Place the extension lead over your shoulder and work first on the large, flat surfaces such
as the bonnet, boot lid and roof.
Keep your movements as regular as possible.
Important! Allow the polishing machine to glide over the polishing surface. Do not exert
pressure!
Work next on the smaller surfaces (doors, for example)
Use the fleece attachment to finish off the polishing.
Make sure that the fleece attachment is free of all foreign bodies.
Remove the layer of polish in the same order as it was applied.
Important! Do not exert pressure on the polishing machine!
CARE TIPS
For optimum paintwork protection, you should polish your car 2 to 3 times a year.
Wash your car at least every 2 weeks. Avoid using household detergents as these can
damage the paintwork and remove the layer of wax.
Wash your car with a clean sponge, working from top to bottom.
Remove all insects, bird droppings and tar stains from the paintwork daily.
If you use any window-cleaning agents, spray them onto a cloth and not directly onto the
windows in order to prevent them wetting the paintwork.
3.1. USING AS A SANDING MACHINE
Use the supplied sanding attachments for sanding purposes.
The Velcro fastener enables easy changing of the sanding attachments.
Place the whole surface area of the sanding disk on the material.
Switch on the machine and move it with gentle pressure over the workpiece completely
circular movements or moving it to and fro and up and down.
Use a coarse paper for coarse sanding and a finer paper for finish sanding. You can find the
best paper for the job by means of testing.
4. SWITCHING THE MACHINE ON
• Check that the switch is in the “OFF/0” position before connecting the machine to the
power supply.
• Press the power switch into the “ ON/1” position to start your Polisher.
• Always keep the power cord out of the way of the tool’s moving parts.
5. TROUBLESHOOTING
Should the machine fail to function correctly, a number of possible causes and the
