8
www.raider.bg
4. Before use
• Before use, vent the system: turn the release valve in the opposite direction of clockwise.
Pump the handle several times to expel air.
• Check all parts for cracks and fractures and, if so, cease work and immediately contact the
supplier.
• Working with the hydraulic press
• Press the saddle and put the work piece.
• Close the valve by turning clockwise.
• Pump the handle until the upper approached to detail.
• Set and align the work piece.
• Pump the handle while pinch detail.
• After operation, stop the pump slowly and carefully off the weight by turning the valve in the
direction counterclockwise in small intervals.
• Remove detail after the complete lifting of the upper saddle.
5. Support.
• Clean the side surfaces of the press with a dry, clean and soft cloth and periodically greasing
compounds and poor function parts with light oil.
• Keep the press in a dry place when not in use fully exempted frame saddles.
• vent the system, as described above.
• Check hydraulic oil, unscrew the nut on top of the tank if the oil is no longer appropriate, fill
with quality hydraulic oil. If necessary, then replace the oil filter and vent system.
6. Environmental Protection.
Hydraulic oil is a liquid that pollutes the environment. Operations associated with topping and
oil change should take precautions against accidental oil leaks. Do not dispose of obsolete
hydraulic jacks with household waste! In view of the environmental transmission of secondary
raw materials, the hydraulic oil must be drained and forward point for processing in accordance
with current rules. Any discharge of hydraulic oil drains or open waters is forbidden.
Parts scheme and components
Important!
Possible changes to the design of the device without warning!
The illustrations are for explanation purposes only and may differ from the actual unit.
