Raider RD-HD38, User Manual

Page: 11 / 68

11
of children and do not allow persons unfamiliar
with the power tool or these instructions to operate
the power tool. Power tools are dangerous in the
hands of untrained users.
1.4.5. Maintain power tools. Check for
misalignment or binding of moving parts, breakage
of parts and any other condition that may affect
the power tool’s operation. If damaged, have the
power tool repaired before use. Many accidents
are caused by poorly maintained power tools.
1.4.6. Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to
control.
1.4.7. Use the power tool, accessories and
tool bits etc. in accordance with these instructions,
taking into account the working conditions and
the work to be performed. Use of the power tool
for operations different from those intended could
result in a hazardous situation.
2. ADDITIONAL SAFETY MEASURES
Be extremely careful about hidden under
plaster electrical lines, plumbing or gas pipes.
Always check the work area (possibly with a metal
detector).
WARNING! Do not carry MACHINE holding it
by the power cord or GRIP!
OPERATING INSTRUCTIONS
REPLACEMENT of the nozzle.
Attention! Whenever replacing a nozzle check
whether Dust cap is not damaged and is in place,
otherwise contact your dedicated service.
SDS system is designed to grip more easily
and more rapidly changing operating ends of
the machine (chisels, drills, etc.). Drill bits are
automatically centered at work, this does not affect
the accuracy of the breach.
WARNING! NEVER USE OTHER THAN
THE SYSTEM TERMINALS SDS - PLUS FREE
outlined for this purpose chuck (SDS-PLUS TO
CONVENTIONAL)!
3. Insert the tip (not included). Clean carefully
tip side contact with the machine, then promazhete
with lubricant (it is necessary to reduce friction at
work). Get back on the grip release mechanism.
Place the mouthpiece in the mouth of grip and
rotate it slightly until the drill bit “sink” into a smooth
grip. Nozzle lock automatically after a release
mechanism to return to the starting position.
4. Replace drill.
Pull back and release mechanism to hold this
position until the download tip.
5. Working with conventional nozzles.
The use of different working ends of the system
SDS - Plus requires the use of a conventional
chuck (not included) mounted on a dedicated
spindle (suitable for SDS grip).
6. Mounting the chuck to grip. (Fig.)
Mounting the chuck is analogous to 1 “attach