31
Maintenance & Storage
1.
Never tamper with safety devices. Check their proper operation regularly. Refer to the
maintenance and adjustment sections of this manual.
2.
Before cleaning, repairing, or inspecting machine, disengage all control levers and stop the
engine. Wait until the auger/impeller come to a complete stop. Disconnect the spark plug wire and
ground against the engine to prevent unintended starting.
3.
Check bolts and screws for proper tightness at frequent intervals to keep the machine in safe
working condition. Also, visually inspect machine for any damage.
4.
Do not change the engine governor setting or over-speed the engine.
5.
Snow thrower shave plates and skid shoes are subject to wear and damage. For your safety
protection, frequently check all components and replace with original equipment manufacturer’s parts
only. ”Use of parts which do not meet the original equipment specifications may lead to improper
performance and compromise safety!”
6.
Never store the machine with fuel in the fuel tank inside a building where ignition sources are
present such as hot water heaters, space heaters, or clothes dryers. Allow the engine to cool before
storing in any enclosure.
7.
Observe proper disposal laws and regulations for gas, oil, etc. to protect the environment.
8.
Prior to storing, run machine a few minutes to clear snow from machine and prevent freeze
up of auger/impeller.
9.
Never store the machine or fuel container inside where there is an open flame, spark or pilot
light such as a water heater, furnace, clothes dryer etc.
10.
Always refer to the operator’s manual for proper instructions on off-season storage.
Assembly
1. Assemble the moving and auger control cable:
Connect the moving control cable (fig.2 A) and auger control cable (fig.2 B) to the right opening as
specified in the following picture.
Fig.2
2. Assemble the handle dashboard:
Put the dashboard (fig.1 point 2) to the lower handle of the machine, and assemble them together with
the bolts. See fig.3.
Fig.3 Fig.4
A
B
A. Moving control cable
B. Auger control cable
D
A
B
C
Summary of Contents for RD-GST04
