13
It has been reported that vibrations from hand-held tools may contribute to a condition
called Raynaud’s Syndrome in certain individuals.Symptoms may include tingling,numbness
and blanching of the fingers,usually apparent upon exposure to cold.Herediitary factors
exposure to cold and dampness,diet,smoking and work practices are all thought to
contribute to the development of these symptoms.Its presently unknown what,if any
vibrations or extent of exposure may contribute to the condition.There are measures that
can be taken by the operator to possibly reduce the effects of vibration:
a)Keep your body warm in cold weather.When operating the unit wear gloves to keep the
hands and wrists warm.Its reported that cold weather is a major factor contributing to
Raynaud’s Syndrome.
b)After each period of operation,exercise to increase blood circulation.
c)Take frequent work breaks.Limit the amount of exposure per day.
If you experience any of the symptoms of this condition,immediately discontinue use and
See your physician about these symptoms.
•
Keep the tool well maintained,fasteners tightened and worn parts replaced.
•
Mix and store fuel in a container approved for fuel.
•
Mix fuel outdoors where there are no sparks or flames.Wipe up any fuel spillage.
•
Move 9m away from refueling site before starting engine.
• Stop the engine and allow to cool before refueling or storing the unit.
•
Allow the engine to cool;empty the fuel tank and secure the unit from moving
•
Before transporting in a vehicle.
SPECIFIC SAFETY RULES FOR POST HOLE DIGGER USE
•
Replace augers if cracked,bent,or damaged in anyway.Be sure the auger and or
•
Extention shaft is properly installed and securely fastened.Failure to do so can cause
• Serious injury.
•
Make sure all guards,straps,deflectors and handles are properly and securely attached.
• Do not start working until you have a clear work area.Do not work near electric cables
• Or underground utilities.It is highly recommended that you check with local authorities
• Before starting to drill.
•
If auger turns whilst the engine is idling,stop the engine and immediately adjust the idle
• Settings following the instructions in this manual.
• Use only the manufacturer’s replacement augers on this unit.Do not use any
• Other attachments.
• Never operate until without the safety clutch in working condition.The safety clutch
• Will engage when the engine is at idle or if a hard object is struck.
• Replace the bit immediately if any cracks or other damage are present.
•
Maintain a firm grip on both handles during operation.
• Never use the drill with the handles above waist level.Drilling with the units handles above
• Waist level restricts control and can cause serious chest injuries if a hand object is struck
• Never carry the power drill with the engine running.
•
Carry the power drill with the engine stopped,and with the auger bit removed.
• Never drill in a horizontal angle.This drill should only be operated with the auger at
a 90
°
angle to the ground
• Always keep the handles dry and clean.
• Before starting to drill make sure the bit is not obstructed.
•
Always work in a firm-footed and safe position.
• Never touch the auger bit or carry out maintenance with the engine running.
•
Grip the post hole digger firmly with both hands and keep all parts of the rountine maintenance.For
other repairs ,have the post hole digger serviced by an authorized repair.
•
Store th e power drill off the ground in a vertical position in a dry place and with fuel tank empty.
Summary of Contents for RD-EA02 SET
Page 80: ...80 www raider bg Exploded drawing of Earth Auger RD EA02 SET ...
Page 89: ...89 ...
Page 93: ...93 ...
Page 95: ...95 ...
