Raider Outboards R504500, Owner'S Manual

Page: 12 / 16

RAIDER SAFETY JET R504500
9
Revision A/2022.05.25//
2. S
AFETY
J
ET
I
NSTALLATION
a. Install the modified zinc anode provided with the Safety Jet using the hardware removed in step
1d.
b. Install the stator onto the lower unit, with the wider-slotted standoff oriented towards the top,
contacting the lower unit above the prop shaft. The narrower-slotted standoff should contact the
skeg.
c. Secure the stator using the longer bolts and wedge-lock washers provided with the Safety Jet.
d. Apply a light coat of marine grease to the rubber seal and the prop shaft and install the brass
spacer onto the shaft, inserting the spacer into the seal.
e. Install the impeller onto the prop shaft.
f. Install the brass washer onto the prop shaft.
g. Secure the impeller with the castle nut and cotter pin provided. Do not over-tighten the castle
nut.
h. Install the nozzle onto the stator, aligning the captive screws in the nozzle with the threaded
holes in the stator.
i. Secure the nozzle by tightening the captive screws using the included T-handle wrench.
Img 2a. Install modified anode Img 2b. Install stator
Img 2d. Install brass spacer into seal Img 2c. Secure with bolts & washers