RAID N8103-134, Setup Manual, Page: 21 / 80

856-127900-408- B
20
Notes on Use - for correct operation of the Product-
Note the following when you use the RAID controller. If you ignore the notes, your assets (including
important data and/or other devices) may be damaged.
The RAID controller is the PCI device for connecting the Serial-Attached SCSI(SAS) devices and
Serial-ATA(SATA)devices at the Express5800 series. You can not use for the other purpose.
„ The RAID controller is an extremely sensitive electronic device. First make your body contact with
metallic frame of the server to discharge static electricity from your body before handling the RAID
controller. Do not drop the RAID controller. Do not make the RAID controller hit against other objects.
„ The RAID controller can connect the hard disk drive or the solid state drive(here after called Physical
Device) of identical standard.
„ For the supported system, additional HDD cage and Physical Device, ask your sales representative.
„ The RAID controller may be limited for intermingling with the other PCI devices (the other RAID
controller, the mirroring board, the SCSI controller). For details on the intermingling with the other
PCI device, ask your sales representative.
„ Please turn off a power supply of a cellular phone near the mainframe by which this product is had
built-in. A radio wave causes a malfunction.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide the reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures.
„ Reorient or relocate the receiving antenna.
„ Increase the separation between the equipment and receiver.
„ Connect the equipment to an outlet on a circuit different from the one to which the receiver is
connected.
„ Consult the dealer or an experienced radio/TV technician for help.
Use a shielded and properly grounded I/O cable to ensure compliance of this unit to the specified limits of
the rules.