MeshGuard User’s Guide
35
6.2 Exiting Diagnostic Mode
Note:
You can exit Diagnostic Mode and enter Programming Mode and
calibrate the MeshGuard as usual by pressing both [MODE] and [N/-] for
three seconds.
Note:
You can exit Diagnostic Mode and enter Detection Mode by
pressing [MODE] and [Y/+] together for three seconds, or by turning it
off and on again.
6.3 Diagnostic Mode Readings
In Diagnostic mode, you can step through readings by pressing [N/-].
6.3.1 Sensor Raw Count
Sensor Raw Count is indicated by “rAU” followed by a number.
•
Press [N/-] to advance to the next reading.
•
Press [MODE] and [Y/+] together for three seconds to exit
Diagnostic Mode and enter Detection Mode.
6.3.2 Battery Raw Count
Battery Raw Count is indicated by “bAt” followed by a number.
•
Press [N/-] to advance to the next reading.
•
Press [MODE] and [Y/+] together for three seconds to exit
Diagnostic Mode and enter Detection Mode.
6.3.3 Temperature Raw Count
Temperature Raw Count is indicated by “tNp” followed by a number.
•
Press [N/-] to advance to the next reading.
•
Press [MODE] and [Y/+] together for three seconds to exit
Diagnostic Mode and enter Detection Mode.
6.3.4 Sudden Power Off Count
Sudden Power-Off Count is indicated by “rSt” followed by a number.
•
Press [N/-] to advance to the next reading.
