Rae EchoView Host, User Manual, Page: 17 / 42

EchoView Host
User’s Guide
17
6
Deploying The EchoView Host
When deploying a wireless portable detector network that utilizes
EchoView Hosts, make sure all units on the network have been set
up with the same PAN ID and Channel number. The EchoView
Host establishes a network automatically with up to eight
instruments.
7
Programming The EchoView Host
Programming Mode is accessed by first providing the correct password.
Press and hold [MODE] and [Y/+] until you see this screen:
Input the 4-digit password:

Increase the number from 0 through 9 by pressing [Y/+].

Decrease the number from 9 through 0 by pressing [N/-].

Step from digit to digit using [MODE].
Once all the four digits have been entered, press [MODE] again to
see the following screen appear. Press [Y/+] to enter the password.
If you make a mistake, you can cycle through the digits by
pressing [MODE] and then using [Y/+] and [N/-] to change the
number in each position.
Note: The default password is 0000.