by Honeywell
Removing An Instrument From A Cradle
To remove an instrument from a cradle, press the button to release the capture mechanism. Then lift the instrument
from its inlet end.
Charging An Instrument
’s Battery
Each AutoRAE 2 Cradle attached to an AutoRAE 2 Controller automatically charges an instrument’s battery when
it is docked. The Charge Status LED glows red to indicate that charging is taking place. When the instrument’s
battery is fully charged, the LED glows green.
Printing Bump/Calibration Reports
Connect a USB cable is connected to a printer and to the USB A port on the side of the AutoRAE 2 Controller and
to the USB port on your printer. Make sure the printer is turned on.
From the main screen, enter Print by pressing [Y/+] (“Function”), and then [N/-] (the cursor arrow) until “Print” is
highlighted. Then press [Y/+] to select it.
Navigate down the list by pressing [N/-], and check/uncheck boxes by pressing [Y/+]. If you select “Print All,” then
“Print All” and all of the other instruments are marked with a check in their checkbox.
If you select specific instruments, then only those will be checked.
After you have made your selections, select [MODE] for “Done.” If a printer is connected, then there is an
automatic countdown, and all selected instrument data is printed.
If you want to stop printing, press [N/-], which aborts printing. You will be asked to confirm that you intend to
abort printing.
Press [Y/+] to abort printing.
Press [N/-] to allow printing to continue.
MultiRAE
ToxiRAE Pro
QRAE 3
