- 8 -
•
Platinum class,
•
Dominant metal content for an alloy.
The above values can be estimated due to method used for metal density
determination.
Owing to measurement of particular sample density, balance software allows to
distinguish between precious metals and common metals.
Standard design balances feature temperature sensor
TB-1
, used in course of
particular sample testing for measurement of liquid temperature.
1.4. Inappropriate use
Do not use the balance as a dynamic weighing instrument. Even if small
quantities of weighed material are added or removed from the weighing pan of
the instrument, the reading should be taken only after stabilisation of the
measurement results. Do not place any magnetic materials on the weighing
pan, as this can cause damage to the measuring system of the instrument.
Be sure to avoid impact shock and overloading the balance in excess of the
prescribed maximum measuring range (max capacity), minus any possible tare
weight that has been applied.
Never use the balance in an environment where explosion is possible. This
balance has not been adjusted for operation in explosive areas.
There must not be any modification made to the balance.
1.5. Warranty
Warranty is invalid for the following:
•
non- observation of the guidelines of this user manual,
•
use of the balance other than specified in this manual,
•
alteration to or opening of the device,
•
mechanical damage and damage caused by media, water, wear and
tear,
•
inappropriate assembling or defects of electric installation,
•
overloading of the measuring mechanism.
1.6. Monitoring the metrological parameters of the instrument
Metrological characteristics of the balance require periodical inspection to be
carried out by its user. Inspection frequency is dependent on ambient conditions
in which the balance is used, types of performed processes and adopted quality
management system.
