ASSEMBLY
[14]
Snowblower Installation with a 3-Point Hitch
1. Figure 2:
Make sure the parking stand is
lowered. To do this, remove the round wire lock
pin (item 9) from the parking stand (item 8),
lower the parking stand and insert the round
wire lock pin (item 9) under the snowblower
attachment tube
.
2. Figure 2:
Category 1
- Attach the tractor lower
arms (item 2) with the two pins (item 1) and
secure with the 7/16" linchpins (item 3) in the
lower holes (item 4).
Figure 2:
Category 2
– Insert the 1 1/8" x
2 1/2" bushing (item 10) in each tractor lower
arms (item 2). Then, attach the tractor lower
arms in the lower holes of the snowblower
(item 4) with a pin (item 1) and secure with a
7/16" linchpin (item 3).
3. Figure 2:
Category 1
- Attach the tractor upper
arm (item 5) between the plates of the
snowblower upper hitch (item 7) with the pin
and the linchpin (item 6) provided with the
tractor.
Figure 2:
Category 2
– Insert a 1" x 1 3/4"
bushing (item 11) in the upper arm of the
tractor (item 5). Then attach the upper arm of
the tractor between the plates of the
snowblower upper hitch (item 7) with the pin
and the linchpin (item 6) provided with the
tractor.
4. Figure 2:
Adjust the snowblower using the
upper arm of the tractor (item 5) so that the
snowblower is perpendicular to the ground
.
5. Figure 2:
Adjust the anti-sway arms of the
tractor to prevent lateral swinging of the
snowblower. Make sure there is no contact with
the tires
.
6. Figure 2:
Raise the parking stand.
To do this,
remove the round wire lock pin (item 9) from
the parking stand (item 8)
, raise
the parking
stand and insert the round wire lock pin
(item 9) over the snowblower attachment tube
.
7.
Go to "
Preparation of the Driveline
" section
for further installation of the blower
.
Before connecting snowblower driveline to
tractor drive shaft, make sure driveline is
not too long in raised, lowered and middle
position. If the driveline is too long it must
be shortened, to avoid damaged to tractor.
See pages 17 and 18 for instructions.
CAUTION
Figure 2
Summary of Contents for 21700001
