6. INSTALLATION REQUIREMENTS
1.
Qualified Installer:
A licensed electrician should be consulted for installation, and electrical installation should be
made in accordance with the national electrical code.
2.
Installation Conditions:
a.
Before starting the installation, you must ensure that the operating voltage corresponds
to that stated on the RADtec specifications label located on the side-panel of the
heater. Supply Voltage fluctuation range should be within ±10%. If condition not
met, it must be resolved before installation
b.
If there is a severe security risk in users’ electricity environment, the installation
should be halted until the security risks are eliminated.
c.
Power lines should be equipped with earth/water leakage protection devices and a
master switch.
d.
The ground wire needs to be connected to the grounding device in the building. If not,
please consult with a professional installer. DO NOT put ground wire to/near a gas
pipe, water pipe, lightning rod or telephone grounding wire.
e.
RADtec recommends an installation height of no less than 6ft (1.8m) above the
ground.
f.
Never locate the heater where it may fall into a bathtub, pool, spa, or other wet area.
Electrical Parameters Table
Model No.
Wattage(W)
Amperage(A)
Voltage(V)
X15R
1500
13.6
110-120
X24R
2400
10.4
220-240
X33R
3300
13.9
220-240
