RADLEY 1282-405, Owner'S Manual

Page: 17 / 23

1282-405
1
6
The staples are
being driven
too deep.
1. The bumper is worn.
2. The air pressure is
too high.
1. Replace the bumper.
2. Adjust the air pressure.
The tool does
not operate
properly - it
does not
drive the
staples or
operates
sluggishly.
1. The air supply is
inadequate.
2. Lubrication is
inadequate.
3. The O-rings or seals
are worn or damaged.
4.
The e haust de ector
in the cylinder head is
blocked.
1. Verify that the air supply is
adequate.
2. Pour up to 6 drops of oil into the air
inlet.
3. Inspect and replace O-rings or
seals.
4. Replace the damaged internal parts.
The tool skips
staples
1. The bumper is
worn, or the spring
is damaged.
2. There is dirt in the
front plate.
3. The O-ring on the
piston is worn or dry
or lubrication is
insufficient.
4. The cylinder cover
seal Is leaking.
1. Replace the bumper or spring.
2. Clean the drive channel on the
front plate.
3. Clean the magazine.
4. Replace the O-ring.
5. Replace the sealing washer.
The tool jams.
1. Improper staples are
used, or staples are
damaged.
2. The driver guide is
damaged or worn.
3. The magazine screw
is loose.
4. There is dirt in
magazine.
1. Use proper staples.
(See section
Clearing
a jammed
staples.
2. Inspect and replace the driver.
3. Tighten the magazine.
4. Open and clean the magazine.
Air exhaust is
being
directed
towards the
operator.
The direction of the
exhaust port requires
adjustment.
Direct the exhaust port away from
the operator.