RADLEY 1282-405, Owner'S Manual

Page: 15 / 23

1282-405
1
4
If it is necessary to store the tool for an extended period of time, apply a generous
amount of lubrication before storing.
The tool should be allowed to run for approximately 30 seconds after lubricating,
in order to ensure that the lubrication is uniformly distributed throughout the tool.
General inspection -
Trigger, spring, None
In-depth inspection
Worn or broken
parts
Replace worn or
broken parts
Lubrication
See below
Pneumatic
tool oil
•
Lubrication: If the tool and the compressor are not
equipped with an in-line lubrication system, place
up to 6 drops of pneumatic tool oil into the air
inlet before each use or after every 2 hours of
continuous use, depending on the characteristics
of the workpiece and type of staples used.