1262-300
12
2.2 AMP 1/4 SHEET PALM SANDER
WARNING
For safety reasons, the operator must read the sections of this Owner’s Manual entitled
“GENERAL SAFETY WARNINGS”, “POWER TOOL SAFETY”, “SPECIFIC SAFETY RULES”,
“GUIDELINES FOR EXTENSION CORDS” and “SYMBOLS” before using this pad sander.
Verify the following every time the pad sander is used:
1. Sander cord is not damaged.
2. Safety glasses and dust mask are being worn.
3. Hearing protection is being worn.
4. Sandpaper is the correct type for the job.
5. Sandpaper is in good condition and is properly installed.
Failure to observe these safety rules will significantly increase the risk of injury.
WARNING
Always wear safety goggles or safety glasses with side shields when operating your
resulting in possible serious eye damage.
Always wear an appropriate dust mask and hearing protection when using your sander.
ON/OFF SWITCH
To turn the switch ON, press the right hand side of the ON/OFF switch (1) (Fig. 7).
To turn the switch OFF, press the left hand side of the ON/OFF switch (2).
SANDING
Clamp or otherwise secure your workpiece to prevent it from moving under
the sander while being sanded.
WARNING
Place the sander on the workpiece so that the complete sandpaper surface is in contact
with the workpiece. Turn the sander ON by pressing on the side of the ON/OFF switch.
Move the sander slowly over workpiece making successive passes in parallel lines,
circles or crosswise movements.
Fig. 7
Summary of Contents for 1262-300
Page 1: ...3 Year Limited Warranty on tool JD2441U...
Page 16: ...15...
