1262-300
10
2.2 AMP 1/4 SHEET PALM SANDER
INSTALLING THE DUST BOX ASSEMBLY
1. Insert the dust duct box assembly sleeve (1) onto the dust chute (2) (Fig. 1).
NOTE: Make sure the locking tabs (3) insert into the matching slots (4) in the rear of
the sander housing.
2. Push the dust box assembly sleeve fully onto the dust chute until the locking tabs
NOTE: Remove and clean the dust box assembly periodically to remove accumulated
dust from the dust box.
CLEANING THE DUST BOX
The dust box will collect much of the sanding dust that is generated during sanding operations.
1. Squeeze the sides of the dust box (1) and pull it away from the rear of the sander (2) (Fig. 2).
2. Pry the top of the dust box (3) away from the bottom of the dust box (4) (Fig. 3).
NOTE: It is best to perform this function either outside or over a trash can, as loose
dust will come out of the dust box very easily.
3. Shake all the dust out of the dust box.
4.
5. Once all the sanding dust is removed from the dust box, press the upper and lower
sections together. They will “snap” into place when properly assembled.
6. Reinstall the dust box onto the rear of the sander.
NOTE: The locking tabs (5) will “snap” into place when the dust box is fully pushed
onto the rear of the sander.
INSTALLING SANDPAPER
WARNING
Unplug the sander from the power source before installing or changing the sandpaper.
NOTE: Cut a standard 9" x 11" sheet of sandpaper into quarters (4½" x 5½").
1. Lift up and outward on the front and rear sandpaper clamp levers (1) at the front
and rear of the backing pad (Fig. 4).
2. Insert one end of the ¼ sheet sandpaper (3) with grit side up into the open front
sandpaper clamp (4), making sure it is aligned with the backing pad. Lift the sandpaper
clamp lever up and inward to lock the sandpaper into the clamp.
Fig. 2
Fig. 1
Fig. 3
Summary of Contents for 1262-300
Page 1: ...3 Year Limited Warranty on tool JD2441U...
Page 16: ...15...
