WiNRADiO G33DDC User’s Manual
115
I can hear the
audio and tune the
receiver, but the
sound is distorted.
Make sure that
AGC
under the
Gain
tab is enabled
and set to medium speed. Try to adjust the
Gain
parameter under the
Audio
tab (excessive audio gain
can cause distortion).
If the S-meter shows the
ADC CLP
message, try to
reduce the signal level using the attenuator.
I can hear the
audio and tune the
receiver, but the
volume is too low,
even if I adjust the
volume control to
maximum.
Presuming the volume is already set to the maximum
level under the
Audio
tab, try to adjust the
Wave
and
Master
volume also in the sound card control panel,
or on the amplified speakers you are using.
Make sure that
AGC
under the
Gain
tab is enabled.
Try to adjust the
Gain
parameter under the
Audio
tab
(excessive audio gain can cause distortion).
I can hear the
audio and tune the
receiver, but the
software is very
sluggish,
sometimes it may
even freeze.
Close all other programs to reduce the burden on the
CPU.
Go to
Options
top bar menu and select
Demodulator
Filter Length
. This function shows the CPU load.
This value should not go over 30%. If it does, this may
indicate insufficient PC resources. You might need to
decrease the filter length (although values under 200
