DSR 9000 Twin 2005.02.04 (GB) - 9
GB
4.4 Installing the Receiver
OPTICAL
TV
ANT
ANT
Installing the Receiver
9
OPTICAL
TV
ANT
* Installing the STB with two Antenna and DiSEqC
switches.
The connection type in LNB setting menu should
be set to Separated.
* Installing the STB with twin LNB Antenna
The connection type in LNB setting menu should
be set to Separated.
DiSEqC
ATTENTION:
Never place the device close to heat sources or in a place where there is strong radiation
from the sun.
Lay all the cables so that they cannot be damaged, e.g. on sharp edges.
Only connect the device to a mains with 95V - 250V~, 50/60Hz supply.
ATTENTION:
Only connect the device to the mains after correctly linking it to the video recorder,
television and any other additional receiver (analogue).
* Use a double-shielded coaxial cable for the coaxial connection cable from the LNB to the
receiver.
ATTENTION:
When fitting the F-connector ensure that no protruding wires from the metal braiding come
into contact with the inner conductor (see Fig.).
There is a risk of a short cut and damage to the receiver on contact!
Wire mesh
Bent wire
Core
* Tighten the lock nut of the F-connector by hand. Ensure that the lock nut is not over tightened.
The receiver has already been pre-programmed in the factory; this means that you can receive
hundreds of programs immediately. You can of course alter this programming or replace it
completely. In order to use all the benefits of the user menu (e.g. channel & program information),
you must make several adjustments which are described in detail in the following chapters.
