Accessory Connector (16 Channel Models Only)
GM300 Radio Service Software Manual
6-2
6880902Z36-B
October, 1996
Customizing the Expanded Accessory Connector
6
Table 6-2 on page 6-19 lists the input functions and Table 6-3 on page 6-20 lists the output functions. Both
tables give the type of function and a short description. For details on each function refer to the RapidCall
Planning Guide. Each function has a function number assigned to it. This number is used to assign a
function to a pin. The Accessory Input and Output Function tables can be used to determine which func-
tions are necessary for your application. Table 6-4 on page 6-21 defines what functions can be assigned to
each pin. Using the tables and the ACCESSORY CONNECTOR CONFIGURATION screen, you should
be able to configure the accessory connector to suit your application.
6.2.1 Accessory Connector Packages
The table below list packages that are available for customizing the Expanded Accessory Connector. A
description and programming procedure for each of the packages
not
marked with an asterisk (*) are
given in this chapter. Descriptions for the packages marked with an asterisk (*) can be found in the
GR300 Repeater Station Manual.
Table 6-1.
Accessory Connector Packages
Community PA *
Public Address
Community Rmt *
Radius RICK-Tx *
DTMF Decoder Board (internal only)
Radius RICK-RX *
General I/O
Remote
Paging Encoder
RPB50 Interface
Phone Base PA-Tx *
Phone Remote PA-Tx *
Phone Base PA-Rx *
Phone Remote PA-Rx *
Phone Base Rmt-Tx *
Phone Remote Rmt-Tx *
Phone Base Rmt-Rx *
Phone Remote Rmt-Rx *
Phone Patch
(*) can be found in the GR300 Repeater Station Manual
