Radiometer Analytical TitraLab 870, Reference Manual

Page: 179 / 286

Titra Lab ® TitraLab 870 Reference Manual
Page 179
Printouts setup Perform the following, before printing:
1. Connect the printer to the Titration Manager.
2. Enter the Setup menu ( Stop , 3 seconds from the Main window).
3. Press 1 Configuration.
4. Select Printer = 80 columns .
5. Select the printout format (Listing or Page by Page).
Refer to "Format (printouts)", page 131 .
6. Press Esc then 3 to customise the printouts, e.g. enter
workstation name.
7. In the Edit method > Printouts, Edit reagent > Printouts and Edit
electrode > Printouts menus define the contents of the printouts.
The Detailed = High/Medium/Low option set the amount of
information that will be printed automaticaly at the end of each
test.
Refer to "Detailed", page 93 .
8. In the Edit method > Printouts menu of an ISE standard addition
method, select whether you want to print or not the GRAN =
f(volume) curve. This curve will be printed automaticaly at the end
of each test.
Refer to "GRAN = f(Volume) curve", page 135 .
9. In the Edit electrode > Printouts menu of an ISE electrode
calibration method, select whether you want to print or not the
calibration curve (E = f(pC = -log C)). This curve will be printed
automaticaly at the end of each calibration cycle.
Refer to "Calibration curve of an ISE electrode", page 72 .
Printouts title Title of the report printout (1 to 23 characters).
Enter in:
Edit method > Printouts
Edit reagent > Printouts
Edit electrode > Printouts