Radiometer Analytical TitraLab 870, Reference Manual

Page: 131 / 286

Titra Lab ® TitraLab 870 Reference Manual
Page 131
Flush burette A flush rinses the burette, tubings and delivery tip thoroughly. It is
recommended to flush the burette on a daily basis.
The Titration Manager carries out a flush after each installation or rea-
gent replacement procedure.
To run a flush:
1. Enter the Burette functions menu.
2. Select the burette in the Address field.
3. Press 3 Flush.
The flush procedure runs as follows:
• Empty,
• Fill 4 ml (*) then empty (5 times).
(*) 1 ml for a 10 ml burette and 10 ml for a 50 ml burette.
The length of the “Flush” procedure depends on the volume of the
burette.
You can also flush simultaneously all installed burettes, see
"Global flush burettes", page 133 .
Format
(printouts) Format = Listing
The whole report is printed in one operation.
Format = Page by page
The printer waits until a preset number of lines have been collected
then prints one page (this number is set by the
Nb line per
page parameter), see "Nb lines per page (printouts)", page 161 .
The printing format applies for automatic printouts (at the end
of a test) or manual printouts (by pressing key
Print ).
Access:
Setup Menu > Configuration
Refer to "Printouts", page 177 .