Radiometer Analytical TitraLab 870, Reference Manual

Page: 72 / 286

Titra Lab ® TitraLab 870 Reference Manual
Page 72
Calculate with
EP no. End point number (1 to Number of EP ) for which the volume will
be used to calculate the result. Depending on the option selected for
Results by cumulate or difference, this will be the volume delivered
from the titration start to the end point no. "n" or the volume delivered
between the end points no. “n-1” and “n”.
Enter in:
Edit method > Results
Calculate with
IP no. Inflection point number (1 to Number of IP ) for which the volume
will be used to calculate the result. Depending on the option selected
for Results by cumulate or difference, this will be the volume delivered
from the titration start to inflection point no. "n" or the volume
delivered between the inflection points no. “n-1” and “n”.
Enter in:
Edit method > Results
Calibrate
electrodes Refer to "Electrode calibration (conductivity)", page 108 .
Refer to "Electrode calibration (ISE)", page 109 .
Refer to "Electrode calibration (pH)", page 110 .
Refer to "Electrode calibration (SAC sequence)", page 111 .
Calibrate
reagents Refer to "Reagent calibration", page 189 .
Refer to "Reagent calibration (SAC sequence)", page 190 .
Calibration
curve of an ISE
electrode This is the E = f (pC = -log C) curve obtained at the end of a
calibration cycle performed on an ISE electrode.
Displaying the calibration curve:
Refer to "Electrode calibration (ISE)", page 109 .
Printing the calibration curve:
The curve is printed out automatically at the end of each calibration
cycle if asked for in the Printouts menu of the calibration method,
see "Printouts setup", page 179 .