RadioLink Electronic Limited
11
Model Name
The system can store the data of 30 models in total. Model name will show on the LCD when you power on
the transmitter. Please make sure the model name is the correct one that you want.
If the model name you chose is not corresponding with your model, the settings should be wrong.
Transmitter Voltage
In addition to the model, LCD can show the voltage of transmitter battery. Users can set transmitter low
voltage alarm in the basic menu -- ALARM. Low voltage alarm of the transmitter is 7.2V by factory default.It
can be customized on 2-4S battery. When the voltage reaches the alarm value, there will be a text displayed
on the transmitter screen and a "didi" sound dual alarm prompt to remind you.
Transmitter function menu setting
When you want to browse or change a setting of transmitter, you should go into function menu setting mode.
Under function menu setting mode, you can set up Language "LANGUAGE" , Model Select "MODEL", End
Point Adjust "EPA", Steering Exponential "STEXP", Steering Speed "STSPD", Throttle Exponential "THEXP",
Throttle Speed "THSPD", A.B.S. Function "A.B.S", Throttle Acceleration "ACCEL", Idle-Up "IDLUP", Sub-trim
"SUB-TRIM", Channel Reverse "REVERSE", Steering/Throttle Dual Rate "D/R", Brake Side Adjustment
"ATL", Programmable Mixes "PMIX01/02", Auxiliary Channel 3, 4, and 5 "AUX-CH"
，
Model name "NAME",
Low Voltage “ALARM”. Gyro Sensitivity”GYRO”, Fail Safe”F/S”, Subsidiary ID”ID SEED”, DSC port setting
"DSC", Timer setting "TIMER", Factory Reset "RESET".
Below menu introduction is based on this firmware V6.7.5. Menus maybe various if the firmware
version is lower. The latest firmware can be downloaded from:
https://www.radiolink.com/rc4gsv3_firmware
2.2 Language "LANGUAGE"
Both English and Chinese version menu are available for which
is convenient for Chinese and English-speaking players
to personalize function menus.
(1) Access the function menu (By pressing “Exit” and “Enter”
buttons simultaneously and holding them down for one second), the
Language select function will be chosen.
(2) Press “Enter” button to get into “LANGUAGE” function interface.
(3) Use“Dec(-)”or “Inc(+)”key to select “
中 文
”or “English”, the selected
language will be with black shading effect.
(4) Press “Enter” button, the desired language is selected, Numbers at the
bottom means the current firmware version. Eg. V6.6.7 in above picture.
2.3 Model Select "MODEL"
RC4GS V3 can store model memories for 30 models. Use this function to
call a new model. Each model can independently set the parameters of
each function.
(1) Access the function menu (By pressing “Exit” and“Enter” buttons
