Previous Settings
To retrieve any one of the last ten settings in pulse mode,
press and hold down the pulse button and at the same time
press either the left or right arrow button. The screen will
cycle through the last ten settings, showing the number of
each setting (1 is the most recent). When you have selected a
setting, release the pulse button and press the OK button. The
pulse mode screen is displayed
with the selected settings.
Timer Mode
It is not possible to activate the timer unless you are using
the GPS version.
If you press the timer button on a non-GPS unit, nothing
will happen and the button press will be ignored.
Contrast Screen
Press the contrast button to adjust the screen
contrast. The Contrast
screen is displayed.
Press the left/right arrow buttons to adjust the contrast to
the desired level. Contrast settings are from 1 (lightest) to
20 (darkest). The setting ‘wraps’ round from 1 to 20. To
select the desired setting, press OK or leave the buttons
untouched for 5 seconds.
Over Temperature Warning
If the Smart Interrupter overheats and operates the thermal
cut-out, the Over Temperature warning screen is displayed.
The Smart Interrupter keeps displaying this screen and all
buttons, except the power- off button, are disabled until
the thermal cut-out resets. Once the cut-out has reset the
Smart Interrupter resumes normal
operation in stopped mode.
Thermal Fuse
A thermal fuse is incorporated into the design to protect
against thermal runaway under fault conditions.
This fuse is not a user replaceable part. If it operates then
the complete smart interrupter must be returned to an
authorised service centre for repair.
