© 2014 Radiodetection Ltd
10
4 Press the battery retaining latch inwards (fig
3.6)
Figure 3.6 Pressing retaining latch
5 Rotate the battery pack away and up from the
latch (fig3.7)
Figure 3.7 Rotating the battery pack
6 Repeat on the other side to release the battery
pack completely
To fit the battery holder follow the steps above in
reverse order.
Transmitters, all models
To replace the batteries on the transmitter, unlatch the
accessory tray. The D-Cell battery tray (see figure 3.4
on page 17) is located underneath the transmitter body.
Use the turnkey to unlatch the battery compartment.
Remove the spent batteries and insert eight D-Cell
Alkaline or NiMH batteries.
3.3 Shutting down
To switch the locator or transmitter off, press and hold
the
key until the screen blanks off.
NOTE: The locator will automatically power off if no
keys are pressed after a five minute duration.
3.4 System setup
The locator and transmitter settings can be
accessed via the menu. Once in the menu it is possible
to change settings according to your personal
preferences and operating requirements. Some
examples of setting changes are shown below.
Please refer to the locator and transmitter menu options
for more information.
NOTE: These procedures refer to both the transmitter
and locator unless stated otherwise.
Before changing settings, ensure the locator or
transmitter is switched on by pressing the
key for two
seconds.
3.4.1 Language
The locator and transmitter support a number of
languages. You can specify your preferred language
using the menu system.
To select your preferred menu language:
1 Press the
key to enter the menu
2 Scroll to the
LANG
menu using the
or
keys
3 Press the
key (on the locator) or the
key (on
the transmitter) to enter the LANG menu
4 Scroll up or down to select your preferred language
5 Press the
key to accept your selection and
return to the main menu.
6 Press the
key to return to the main operation
screen.
3.4.2 Battery type
locators and transmitters support Li-ion,
Alkaline or NiMH batteries.
By default your locator battery type is set to
Li-ion.
It is important that you set the system to match the
currently installed battery type to ensure optimal
performance and correct battery level indication.
To set your battery type:
1 Press the
key to enter the menu
2 Scroll to the
BATT
menu using the
or
arrows
3 Press the
key ( on the locator) or the
key (on
the transmitter) to enter the BATT menu
4 Scroll up or down to select the correct battery type
Summary of Contents for rd7000+
Page 4: ... 2014 Radiodetection Ltd iii ...
Page 5: ... 2014 Radiodetection Ltd iv ...
Page 10: ... 2014 Radiodetection Ltd 3 ...
