16
3. Press the
[*SCAN]
to begin DCS scanning
A
fl
ashing "DCS" will be in the le
�
status display to indicate the radio is in DCS scanning mode. In this mode, whenever the
radio is receiving an RF signal on the selected MR channel or VFO frequency, the lower display will cycle through the DCS
codes as they are being tested. Once the bits of the received DCS code are determined, the "DCS" indicator will stop
fl
ashing.
Press the
[MENU]
key to save the scanned tone into memory (VFO Mode Only) then press the
[EXIT/AB]
key to exit the
menu.
Don't forget to set VFO menu 10 back to OFF when the DCS tone is no longer required.
6.4 Dual Watch
The
Radioddity
GT-82
features Dual Watch func
�
onality (single receiver) with the
ability
to
lock
the
transmit
frequency
to
one
of
the
two
channels
it
monitors.
•
Enabling or disabling Dual Watch mode
1. Press the [MENU] [7] to get to MENU 7:
TDR
.
2. Press [MENU] key to select.
3. Use the
▲
and
▼
keys to enable or disable.
4. Press the [MENU] key to con
fi
rm.
5. Press the [EXIT/AB] key to exit the menu.
Due to the way the
Radioddity GT-82
is constructed , whenever one of the A or B Frequencies (VFO/MR) goes ac
�
ve, it will
default to transmit on that
channel.
This
behavior
can
be
inconvenient,
especially
if
when
monitoring
a
frequency,
you
should
not
transmit
on.
There
is
a
menu
op
�
on
available
to
lock
the
transmi
�
er
to
one
of
the
A
or
B
channels.
•
Locking the Dual Watch transmit channel
1. Press the [MENU] [3][4] to get to MENU 34: TDR-AB.
2. Press [MENU] key to select.
3. Use the
▲
and
▼
keys to select A (upper) or B (lower) display.
4. Press the [MENU] key to con
fi
rm.
