Radiocrafts
Embedded Wireless Solutions
RC2300DK
2007 Radiocrafts AS
RC2300DK- Demonstration Kit Quick Start (rev. 1.0)
Page 3 of 3
4. Set the frequency by pressing “3” (a list of channels will appear) and then by pressing
the “number” corresponding to the wanted channel. The same channel must be set
on each board.
5. For one of the boards press “1” to start packet transmission
(The transmitter can now be disconnected from the RC232 cable if it needs to be
mobile – A reset/power off-on will require a new setup from HyperTerminal)
6. For the second board press “2” to start receiving
Figure 3 Screen shot when receiving
PER = B/G/N
B = Bad packages (CRC Not OK)/Lost packages
G = Good packages (CRC OK)
N = Number of sent packages (Always 100)
RSSI = Received signal strength indication
Contact Information
Radiocrafts AS
Sandakerveien 64
NO-0484 OSLO
NORWAY
www.radiocrafts.com
Tel: +47 4000 5195
Fax: +47 22 71 29 15
ZigBee
®
is a trademark of the ZigBee Alliance. © 2007, Radiocrafts AS. All rights reserved.
