RC16xxxx-SSM
2017 Radiocrafts AS
RC16xxxx-SSM User Manual (rev. 1.00)
Page 10 of 20
Radiocrafts
Embedded Wireless Solutions
Test mode 2
‘2’ – 0x32 (none)
TX modulated signal PN9
sequence
Test mode 3
‘3’ – 0x33 (none)
TX Off, RX mode
Test mode 4
‘4’ – 0x34 (none)
IDLE
*
Test mode 5
‘5’ – 0x35 (none)
Transmits 1 packet on
Channel 200.
**
Test mode 5
‘5’ – 0x35 (none)
TX carrier
921,3875 MHz (Domain 3)
903,3875 MHz (Others)
*
Test mode 6
‘6’ – 0x36 (none)
Waits 30s to receive a packet
on channel 200 with the
Sequence number 10. The
received packet is sent out
on UART.
**
Test mode 6
‘6’ – 0x36 (none)
TX carrier
922,6625 MHz (Domain 3)
904,6625 MHz (Others)
*
Test mode 7
‘7’ – 0x37 (none)
Send 200 packets with
frequency hopping.
**Test mode 7
‘7’ – 0x37 Arg_0, Arg_1, Arg_2
SIGFOX_API_test_mode
(Arg_0, Arg_1)
Test mode 8
‘8’ – 0x38 (none)
Verify EEPROM.
*Available on RC1682-SSM only.
**Available on RC1692HP-SSM only.
Note:
ASCII characters are written as ‘X’, hexadecimal numbers are written like 0x00, and
decimal numbers are written like 10 throughout the text. A table of ASCII characters and their
respective hex and decimal values are found in the Appendix.
Any invalid co
mmand will be ignored and the ‘>’ prompt will be re-sent.
If Test mode 1 or 2 is used, it is important to enter Test mode 3 before exiting the
configuration mode (‘X’) in order to ensure proper operation in normal mode
.
Example:
To change the SIGFOX mode to Uplink and Downlink, use the following sequence:
Command
Hex
Response
Comment/Note
Enter
0x00
‘>’
Or assert CONFIG pin
De-
assert CONFIG after ‘>’ prompt
‘F’
0x46
‘>’
1
0x01
‘>’
Wait for ‘>’ prompt
[A new command could be issued here]
‘X’
0x58
(none)
Module returns to IDLE state
Note that the CONFIG line must be de-
asserted after the first ‘>’ prompt was received, but
before the ‘X’ command.
