PG
8
HVAC Selection
• Set
the
HVAC TYPE
switch in the
NORM
position if you have conventional
natural gas, propane, oil, or electric heat. If you have a HEAT PUMP system set
the
HVAC TYPE
switch to
HP
. They are located in the battery compatrment.
• Set
the
HEAT TYPE
switch in the
GAS
position if you have normal gas or oil heat
or if you have a heat pump with gas or oil auxiliary heat. Put the
HEAT SOURCE
in
the
ELEC
position if you have normal electric heat or if you have a heat pump with
electric auxiliary heat.
Install 4 AA Batteries
• Install 4 AA alkaline batteries [required] following the
marked polarity in the battery compartments. Put the
battery in negative end first against the spring, then
push the positive end in.
IMPORTANT:
Press the RESET button (under top
cover) to implement the HVAC switch selections.
• With all the wires connected it is time to turn the AC power back on. Do this at the breaker you used
to switch it off. The CT101 will power-up in the OFF mode. Your CT101 is not configured to operate
your HVAC system yet. You must now configure your thermostat for your HVAC system.
AA
AA
AA
AA
HEAT
�
PUMP
HVAC
T
YPE
HVAC
TYPE
HEAT
�
T
YPE
HEAT
TYPE
NORMAL
GA
S
ELEC
