background image

18

www.xmodsRC.com

www.xmodsRC.com

19

Troubleshooting

Vehicle does not move or cannot be steered.

• Batteries for vehicle and/or controller are week or dead. Replace the batteries (or recharge if 

you are using rechargeable batteries for the vehicle).

Note:

When the power light on the controller blinks, the battery is low. Replace the battery.

• Static discharge might have caused controller malfunction. Turn the controller off and then 

back on.

• Check the wheel mechanisms for lint, thread, hair, or dust.
• Move closer to the vehicle and try again.

Vehicle does not drive straight even when you release the steering wheel.

• Adjust

ST TRIM

 on the controller. See “

Steering Trim

” on Page 14.

Controlling range seems to become shorter.

• Check the frequency of neighbor driver’s vehicle. The same or adjacent frequency vehicles 

might interference each other. See “

Additional Notes

” on Page 15.

RF Emissions Information

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference 

in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not 

installed and used in accordance with the instructions, may cause harmful interference to radio communications. 

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does 

cause harmful interference to radio or television reception, which can be determined by turning the equipment off 

and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help

&KDQJHVRUPRGLÀFDWLRQVQRWH[SUHVVO\DSSURYHGE\,JQLWLRQ/3PD\FDXVHLQWHUIHUHQFHDQGYRLGWKHXVHU·V

authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This 

device may not cause harmful interference, and (2) this device must accept any interference received, including 

interference that may cause undesired operation.
Frequency range: 26.975 – 27.255 MHz. Field strength: 27.125 MHz – 75.3 dB

μ

V/m at 3 m.

Only use the antenna attached to this product.

Protect the environment by recycling used electronics. 

Go to E-CyclingCentral.comWRÀQGDUHF\FOHFHQWHUQHDU\RX

Summary of Contents for XMODS 60-437












Reviews: