background image

14

www.xmodsRC.com

www.xmodsRC.com

15

Fine Tuning

Steering Range

Set

ST RANGE

 to adapt your car’s steering angle to different track conditions. Set it to 

MAX

(right) for sharp turns and to 

MIN

 (left) for loose turns.

Throttle Trim

Set

TH TRIM

 on top of the controller to control your car’s acceleration. Set it to 

LO

 for 

maximum maneuverability on a race track with lots of curves and 

HI

 for maximum speed.

Steering Trim

If your car does not drive straight when you release the steering wheel, adjust 

ST TRIM

 on top of 

the controller. Place the vehicle on a block or turn it over so the tires do not touch the ground. Turn 

the transmitter and vehicle on, and press 

L

 or 

R ST TRIM

 until the tires point directly forward.

(

Note: ST TRIM

will revert to the factory setting when the controller is turned off.)

When You Finish Driving

• Slide the power switch on the controller to the 

OFF

 position.

• Slide the power switch on the bottom of the car to the 

OFF

 (rear) position.

• To store your controller, unscrew the antenna and place it in its channel in the controller. 

Slide the 

Lock

 switch to fold your controller.

‡ 0DNHLWDKDELWWRUHPRYHWKHEDWWHULHVIURP\RXUYHKLFOHDIWHU\RXÀQLVKGULYLQJ2YHUWLPH

batteries can leak chemicals that may destroy electronic parts.

Care

• Keep your XMODS car and controller dry; if they get wet, wipe them dry immediately. 
• Use and store only in normal temperature environments. 
• Running your XMODS continuously for long periods can generate high heat levels. 
• Handle your XMODS car and controller carefully and do not drop them. 
• Keep away from dust and dirt. You can wipe your car and controller with a damp cloth occasionally to 

keep them looking new.

• Modifying or tampering with your XMODS’ internal components can cause a malfunction and might 

invalidate its warranty and void your FCC authorization to operate it. If your XMODS is not performing as 

it should, take both the car and the controller to your local XMODS dealer for assistance.

Additional Notes

• XMODS Street car bodies and chassis are not compatible with 1st Generation or EVO series. All parts are 

compatible only with XMODS Street products.

• CB radios and other RC controllers could interfere with your ability to control the car. If this happens, 

increase the distance between the interfering devices until normal control of your vehicle resumes.

• You cannot operate your car near devices with controllers that use the same frequency. The frequency 

XVHGLQ\RXU;02'6LVLGHQWLÀHGE\%DQG1XPEHUZKLFKLVODEHOHGRQWKHWRSFHQWHURIWKHFKDVVLV6HH

the following frequency chart:

Band No.

Frequency

Band No.

Frequency

1

26.995

7

26.975

2

27.045

8

27.025

3

27.095

9

27.075

4

27.145

10

27.125

5

27.195

11

27.175

6

27.255

12

27.225

Summary of Contents for XMODS 60-437












Reviews: