21
Answering System Operation
3. If the PIN is correct, the system
announces the day and time, then it
announces the number of new and old
messages. The system plays all new
messages then beeps about once every
two seconds to let you know it is ready
to accept remote commands.
Notes:
• If the system does not respond, try
entering your PIN again. If you enter an
incorrect PIN three times, the system
beeps and hangs up.
• When the system is in remote operation,
it stops all answering functions and the
display on the base shows
rC
. The sys-
tem resumes answering functions when
it is no longer in remote command if you
have not turned it off.
• The maximum length of a memo
recorded by remote operation is 4 min-
utes.
• The remote playback of incoming mes-
sages is limited to 4 minutes. If you have
more messages after 4 minutes have
passed, you must press #
2
again to lis-
ten to the rest of the messages.
• When using remote operation, you can
only delete the current message during
playback. You cannot delete all the mes-
sages stored at one time.
4. To use a remote command, press
#
and
(within 2 seconds) the number for the
command you want.
Note: The remote operation stops when
someone picks up the handset or any phone
on the same phone line.
Remote Commands
Press #,
then
To
1
Repeat current message during play-
back.
2
Play messages.
3
Skip current message during play-
back.
4
Delete current message during play-
back.
5
Stop playback, recording, and room
monitoring.
6
Set the system to answer calls.
7
Record or stop recording a memo.
8
Record or stop recording a new out-
going message.
9
Set the system not to answer calls.
Monitor the room where the system is
located for 15 seconds.
43-3806.fm Page 21 Tuesday, August 8, 2000 11:29 AM