10
Quick Start
step 5: monitoring and scanning
monitoring
To monitor a channel, press
SCAN/MANUAL
while the scanner is
pausing on the channel, or stop the scanning by pressing
SCAN/
MANUAL
, enter the channel number, and press
SCAN/MANUAL
.
scanning
To scan, press
SCAN/MANUAL
. When the scanner
fi
nds a
transmission, it monitors the transmission until it ends.
•
If you have not stored frequencies into any channels,
the scanner cannot scan.
•
If the scanner picks up weak transmissions, turn
SQUELCH clockwise to decrease the scanner’s
sensitivity to these signals. To listen to a weak or
distant station, turn SQUELCH counterclockwise.
Press
SCAN/MANUAL
to stop scanning, or press
HOLD/RESUME
to pause the scan without losing your position.
earphones / headphones
For private listening, you can plug earphones or headphones into
your scanner’s headphone jack. Do not use headphones with your
scanner when operating a motor vehicle in or near traf
fi
c. Doing so
can create a traf
fi
c hazard and could be illegal in some areas. Some
headphones let you hear some outside sounds when listening at
normal volume levels, but they still can present a traf
fi
c hazard.
To protect your hearing, follow these guidelines for headphones.
•
Do not listen at extremely high volume levels. Extended high-
volume listening can lead to permanent hearing loss.
•
Set the volume to the lowest setting before you begin listening,
then adjust the volume to a comfortable level.
•
After you set the volume, do not increase it. Over time, your
ears adapt to the volume level, so a volume level that does not
cause discomfort might still damage your hearing.
NOTES
