8
5. Plug the other end of the two-line
short modular cord into the wall
plate jack. If you attached a long
modular cord, plug it into the wall
jack. Align the wall plate studs with
the phone's keyhole slots and slide
the phone downward to secure it.
6. Plug the adapter into a standard AC
outlet.
On a Wall
To mount your phone on a wall, you
need two screws (not supplied) with
heads that fit into the keyhole slots on
the bottom of the phone.
1. Drill two holes 3
15
/
16
inches (100 mm)
apart. Then, thread a
screw into each hole,
letting the heads
extend about
3
/
16
inch
(5 mm) from the wall.
2. Remove the bracket by holding in
the tab on the right side of the
bracket and gently pulling the
bracket away from the base.
3. Insert the bracket’s two small tabs
into the matching slots at the lower
right on the bottom of the phone,
and snap the large tab into the large
slot at the lower left.
4. If you have a single two-line phone
jack, plug one end of the supplied
two-line short modular cord into
L1
or L1/L2
on the back of the phone's
base.
If you have a single one-line phone
jack, and there is another modular
telephone line jack close by, plug
one end of the supplied two-line
short phone cord into
L1 or L1/L2
,
and plug the supplied one-line long
phone cord into
L2
.
3
/
16
3
15
/
16
L1/L2
43-469.fm Page 8 Tuesday, January 19, 1999 9:48 AM
