Using Your Phone
9
telephone numbers. You can store your most frequent
dialed number in the one-touch speed dial location.
Ô
1. Remove the handset from the base.
2. Press
MEM
. The TALK/BATT LOW flashes.
3. Enter the phone number, up to 20 digits. If a pause is
needed during the dialing sequence, press
REDIAL/
PAUSE
to insert a pause. Each pause counts as a digit
and represents a two second delay in time between
digits as they are sent.
4. Press
MEM
again.
To actually store a number in it’s designated location;
5. Press
SPEED DIAL
or memory location (
0
-
9
) on the
keypad to store a number.
A tone indicates that the number is stored. If you enter a
number in a location that has a previously stored number it
will overwrite the existing number without warning.
Dialing a Memory Number
1. Press
talk
, then press
MEM
.
2. Enter the memory location (
0
-
9
) on the keypad. The
stored number automatically dials.
Ô
One-touch Speed Dial
Your phone is equipped with “One-touch speed dial” for
instant dialing. It is used to dial the phone number stored in
the one-touch speed dial location (See “Storing a Phone
Number in Memory”).
To instantly dial the phone number stored in the one-touch
speed dial location, simply press
SPEED DIAL
. (There is no
need to press
talk
. The phone will automatically dial). If you
press
SPEED DIAL
and a phone number is not stored in the
one-touch speed dial location, the phone will beep rapidly
and will not dial.
Chain Dialing
The memory locations on the handset are not limited to
phone numbers. You can also store a group of numbers (up
to 20 digits) that you need to enter once your call connects.
This is referred to as Chain Dialing.
An example of this is a bank account number. Once you
have called your bank, and are prompted to enter the
account number, simply press
MEM
and the location
number (
0
-
9
) where the special number has been stored.
Store your special number in memory as you would store a
phone number (Refer to “Storing a Phone Number in
Memory”).
Erasing a Stored Number from Memory
1. Remove the handset from the base unit.
2. Press
MEM
twice.
Ô
NOTE
Ô
If you select a memory location that
does not have a stored number,
the handset will beep rapidly and
the phone will not dial.
43-3546.fm Page 9 Thursday, February 27, 2003 10:39 AM