Radio Pulse MG2475-EVK, Getting Started

Page: 19 / 27

ASW1003 [MG2475-EVK] Getting Started
V1.0 Page:19/27
www.radiopulse.co.kr
7.3.8. TX-Station : Set Transmitting Parameters for PER (Optional)
Press
‘2’. Then, type the value to use for each parameter and press [ENTER].

The number of packets to transmit. : Defines the number of packets to be
transmitted. This step can be skipped if changing is not needed or using
‘1000’, the
default value.

The interval between two packets : Defines the time from last packet
’s finishing to
next packet
’s starting in milli-seconds. This step can be skipped if changing is not
needed or using
‘10’, the default value.
1st transmission 2nd transmission
Interval
3rd transmission
Interval

The length of a packet : Defines the length of a transmitted packet (PSDU) in bytes.
This step can be skipped if changing is not needed or using
‘32’, the default value.
PHY Payload(PSDU, PHY Service Data Unit)
PHY
MAC
MAC Header
MAC Payload
(MSDU, MAC Service Data Unit)
MAC Footer
(2 Bytes)
< IEEE 802.15.4 Frame Structure >
PSDU
Length

AckRequest : Defines whether ACK packet is requested or not. If AckRequest is
equal to 1, the transmission is successful when the TX-Station receives the ACK
packet. This step can be skipped if changing is not needed or using
‘1’, the default
value.
TX-Station RX-Station
Packet with AckRequest=1
< Transmission with ACK >
TX-Station RX-Station
Packet with AckRequest=0
< Transmission with NO-ACK>
ACK packet